EasyManuals Logo
Home>HIKVISION>Security Camera>DS-2CD1043G0E-I

HIKVISION DS-2CD1043G0E-I User Manual

HIKVISION DS-2CD1043G0E-I
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Network Bullet Camera·Quick Start Guide
3
IN THE EVENT OF ANY CONFLICTS BETWEEN THIS MANUAL AND THE
APPLICABLE LAW, THE LATER PREVAILS.
Regulatory Information
FCC Information
Please take attention that changes or modification not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
FCC compliance: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help
FCC Conditions

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-2CD1043G0E-I and is the answer not in the manual?

HIKVISION DS-2CD1043G0E-I Specifications

General IconGeneral
Sensor typeCMOS
Progressive scanYes
Number of sensors1
Optical sensor size1/3 \
DC output current0.35 A
DC output voltage12
Power source typeDC, PoE
Power consumption (max)4.2 W
Fixed focal length2.8 mm
Maximum aperture number2
Pan range0 - 360 °
Tilt angle range0 - 180 °
Angle of rotation360 °
Camera shutter speed1/3 - 1/100000 s
Minimum illumination0.028 lx
TypeIP security camera
Certification47 CFR 15, B; EN 55032: 2015, EN 61000-3-2: 2014, EN 61000-3-3: 2013, EN 50130-4: 2011 +A1: 2014; AS/NZS CISPR 32: 2015; ICES-003: 6, 2016; KN 32: 2015, KN 35: 2015 UL 60950-1, IEC 60950-1:2005 + Am 1:2009 + Am 2:2013, EN 60950-1:2005 + Am 1:2009 + Am 2:2013, IS 13252(1):2010+A1:2013+A2:2015, IEC/EN 60950-1
Placement supportedOutdoor
Connectivity technologyWired
Built-in HDDNo
Total megapixels4 MP
Maximum resolution2560 x 1440 pixels
Image quality adjustmentBrightness, Contrast, Saturation, Sharpness
Video compression formatsH.264, H.264+, H.265, H.265+, M-JPEG
Noise reduction technology3D noise reduction
Supported graphics resolutions320 x 240, 640 x 360, 640 x 480 (VGA), 1280 x 720 (HD 720), 1920 x 1080 (HD 1080), 2304 x 1296, 2560 x 1440
Number of users32 user(s)
Networking standardsIEEE 802.1x, IEEE 802.3af
Ethernet interface typeFast Ethernet
Supported network protocolsTCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, NTP, UPnP, SMTP, IGMP, 802.1X, QoS, IPv6, UDP, Bonjour
LED typeIR
Infra-red wavelength850 nm
Night vision distance30 m
Operating temperature (T-T)-30 - 60 °C
Operating relative humidity (H-H)0 - 95 %
Form factorBullet
Mounting typeCeiling/wall
Product colorWhite
Housing materialMetal, Plastic
International Protection (IP) codeIP67
Weight and Dimensions IconWeight and Dimensions
Depth67.8 mm
Width66.2 mm
Length177.6 mm
Weight280 g
Package depth121 mm
Package width216 mm
Package height118 mm
Package weight501 g

Related product manuals