EasyManuals Logo
Home>HIKVISION>Security Camera>DS-2CD1043G0E-I

HIKVISION DS-2CD1043G0E-I User Manual

HIKVISION DS-2CD1043G0E-I
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
Network Bullet Camera·Quick Start Guide
6
In the use of the product, you must be in strict compliance with
the electrical safety regulations of the nation and region. Please
refer to technical specifications for detailed information.
The power source should meet limited power source or PS2
requirements according to IEC 60950-1 or IEC 62368-1
standard.
Do not connect several devices to one power adapter as
adapter overload may cause over-heating or a fire hazard.
Please make sure that the plug is firmly connected to the power
socket. When the product is mounted on wall or ceiling, the
device shall be firmly fixed.
If smoke, odor or noise rise from the device, turn off the power
at once and unplug the power cable, and then please contact
the service center.
Cautions
CAUTION: Hot parts! Burned fingers when handling the parts.
Wait one-half hour after switching off
before handling parts. This sticker is to
indicate that the marked item can be hot
and should not be touched without
taking care. For device with this sticker, this device is intended
for installation in a restricted access location, access can only be
gained by service persons or by users who have been instructed
about the reasons for the restrictions applied to the location
and about any precautions that shall be taken.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HIKVISION DS-2CD1043G0E-I and is the answer not in the manual?

HIKVISION DS-2CD1043G0E-I Specifications

General IconGeneral
Sensor typeCMOS
Progressive scanYes
Number of sensors1
Optical sensor size1/3 \
DC output current0.35 A
DC output voltage12
Power source typeDC, PoE
Power consumption (max)4.2 W
Fixed focal length2.8 mm
Maximum aperture number2
Pan range0 - 360 °
Tilt angle range0 - 180 °
Angle of rotation360 °
Camera shutter speed1/3 - 1/100000 s
Minimum illumination0.028 lx
TypeIP security camera
Certification47 CFR 15, B; EN 55032: 2015, EN 61000-3-2: 2014, EN 61000-3-3: 2013, EN 50130-4: 2011 +A1: 2014; AS/NZS CISPR 32: 2015; ICES-003: 6, 2016; KN 32: 2015, KN 35: 2015 UL 60950-1, IEC 60950-1:2005 + Am 1:2009 + Am 2:2013, EN 60950-1:2005 + Am 1:2009 + Am 2:2013, IS 13252(1):2010+A1:2013+A2:2015, IEC/EN 60950-1
Placement supportedOutdoor
Connectivity technologyWired
Built-in HDDNo
Total megapixels4 MP
Maximum resolution2560 x 1440 pixels
Image quality adjustmentBrightness, Contrast, Saturation, Sharpness
Video compression formatsH.264, H.264+, H.265, H.265+, M-JPEG
Noise reduction technology3D noise reduction
Supported graphics resolutions320 x 240, 640 x 360, 640 x 480 (VGA), 1280 x 720 (HD 720), 1920 x 1080 (HD 1080), 2304 x 1296, 2560 x 1440
Number of users32 user(s)
Networking standardsIEEE 802.1x, IEEE 802.3af
Ethernet interface typeFast Ethernet
Supported network protocolsTCP/IP, ICMP, HTTP, HTTPS, FTP, DHCP, DNS, DDNS, RTP, RTSP, NTP, UPnP, SMTP, IGMP, 802.1X, QoS, IPv6, UDP, Bonjour
LED typeIR
Infra-red wavelength850 nm
Night vision distance30 m
Operating temperature (T-T)-30 - 60 °C
Operating relative humidity (H-H)0 - 95 %
Form factorBullet
Mounting typeCeiling/wall
Product colorWhite
Housing materialMetal, Plastic
International Protection (IP) codeIP67
Weight and Dimensions IconWeight and Dimensions
Depth67.8 mm
Width66.2 mm
Length177.6 mm
Weight280 g
Package depth121 mm
Package width216 mm
Package height118 mm
Package weight501 g

Related product manuals