Note: The “bottom” mark on the mounting base should align with the “bottom” mark on the mounting
bracket.
Figure 4-5 Secure the Camera
3. View the image of the camera over the network.
4. Loosen the screws on the bracket slightly.
Note: Please loosen the screws slightly until you can adjust the camera and do not remove the screws from
the bracket.
5. Adjust the camera to the desired surveillance angle and then tighten the screws on bracket to fix the
camera.
Figure 4-6 Adjust Image
6. Loosen the lock screw on the sun shield and move the sun shield until you can remove it. Remove the sun
shield.
Figure 4-7 Remove the Sun Shield
7. Rotate to remove the front cover from camera and adjust the lens to get a clear image.
To Next Page
Loading...
