1. Disassemble the camera. Refer to section 2.1.
2. View the camera image using the monitor.
3. Loosen the zoom lever and move the lever between T(Tele) and W(Wide) to obtain the
appropriate angle of view.
4. Tighten the zoom lever.
5. Loosen the focus lever and move the screw between F(Far) and N(Near) to obtain the
optimum focus.
6. Tighten the focus lever.
7. Assemble the camera. Refer to section 2.1.
Figure 4-34 Zoom and Focus Adjustment
Chapter 5 Cube Camera Installation
To Next Page
Loading...
