3. Repeat steps 5 to 9 of 2.2.2 Ceiling Mounting with
Junction Box to finish the installation.
Figure 2-18 Finish Installation
2.3 Installation of Type III Camera
2.3.1 Ceiling Mounting Without Junction Box
Steps:
1. (Optional) For cement ceiling, drill the screw holes
with a 5.5 mm drill and insert the supplied wall
plugs.
2. (Optional) Drill the cable hole, when the cables are
routed through the ceiling.
3. Secure the base plate (supplied) to ceiling with four
screws.
Figure 2-19 Secure Base Plate to Ceiling
4. Loosen the screws to remove the bubble.
Figure 2-20 Remove Bubble
5. Align the mark on camera with the vertical line on
base plate, and rotate the camera to fix it on the
plate.
Figure 2-21 Fix Camera to Base Plate
To Next Page
Loading...
Need help?
General
