HIKVISION DS-2DE5232W-AE3 - Set Device Position; Set Power off Memory; Set PTZ Priority

Note
Acve zoom rao is only supported for the PTZ channel.
6.
Repeat the steps above to set other privacy masks.
7.
Check Enable Privacy Masks.
4.10 Set Device Posion
Before You Start
Go to Conguraon → PTZ → Basic Sengs → PTZ OSD to enable PT Status display.
Use other direcon indicang devices to nd the North at the device locaon.
Steps
1.
Go to Conguraon → PTZ → Posion Sengs .
2.
Manually set device direcon by selecng the PT Mode as Manual.
1) Adjust the
lt posion of the device to 0 by controling the up arrow and down arrow on the
PTZ panel.
2) Adjust the pan posion to show the live view of the north direcon by controling the le
arrow and right arrow on the PTZ panel.
3) Click Set as North.
3.
Input the longitude and
latude of the device manually.
4.
Click Save.
What to do next
If you lost
direcon when operang the device, you can click Point to North to call the north
posion that is saved in the device.
4.11 Set Power
O Memory
This funcon can resume the previous PTZ status of device aer it restarng from a power-o.
Steps
1.
Go to Conguraon → PTZ → Basic Sengs .
2.
Select Resume Time Point. When the device stays at one
posion for the set resume me point
or more, the posion is saved as a momory point. The device returns to the last memory point
when it restarts.
3.
Click Save.
4.12 Set PTZ Priority
The funcon can set the PTZ priority of dierent signals.
Network Speed Dome User Manual
22