3 Installation
Before you start:
● Suitable certified flameproof 'd' and dust ignition protection 't'
cable glands, correctly installed and suitable for the conditions
of use.
● IECEx/ATEX certified cable glands are needed during the
installation.
● Make sure the device in the package is in good condition and all
the assembly parts are included.
● The standard power supply is 100 to 240 VAC, please make sure
your power supply matches with your camera.
● Make sure all the related equipment is power-off during the
installation.
● Check the specification of the products for the installation
environment.
● Make sure that the wall is strong enough to withstand four
times the weight of the camera and the bracket.
For the camera that supports IR, you are required to pay attention to
the following precautions to prevent IR reflection:
● Dust or grease on the dome cover will cause IR reflection.
Please do not remove the dome cover film until the installation
is finished. If there is dust or grease on the dome cover, clean
the dome cover with clean soft cloth and isopropyl alcohol.
To Next Page
Loading...
Need help?
General
