DS-7600 Series NVR User Manual
60
5. Click START CLIPPING.
6. Select the ending time of the incident.
7. Click END CLIPPING (same button as Start Clipping).
8. Repeat steps 1–7 as many times as required.
9. Click EXIT or right-click.
10. Click YES to save clipping. After pressing YES, a new window pops up containing all saved clips.
NOTE: The Start button is not available when there is a video clip that has not been saved or cleared.
Figure 71, Clips Export Interface
11. Select the desired clips.
12. Press EXPORT.
13. Once the backup is complete, simply remove the USB FLASH Drive or the USB HDD.
To Next Page
Loading...
