DS-7600 Series NVR User Manual
66
5. Alarm Host: Send the alarm event or exception message to the alarm host when an alarm is triggered. The remote alarm host must
have the CMS (Client Management System) Software installed.
• Enter the IP address of the remote PC on which the CMS Software is installed in.
• Enter the alarm monitoring port in Alarm Host Port, which must be the same as the port configured in the software.
6. Port:
• Server Port: Enter the Server Port which designates the port to be used with the client software.
• HTTP Port: Enter the HTTP Port which refers to the one to be used with the built-in Web Server.
• Multicast IP: Enter the Multicast IP to enable multicast.
• RTSP Port: Enter the PTSP Port. PTSP is a network control protocol designed for use in entertainment and communication
systems to control streaming media servers.
7. Enable Virtual Host: You can enable the virtual host function based on your need.
8. Click Apply to save the network settings and click to return to the previous menu. Click without clicking Apply will quit
out of the menu without saving settings.
NOTE: If you enable the high-speed download function, the local menu operation will be affected. It is recommended to
disable this function after finishing the remote downloading of record files.
Managing User Accounts
By default, your NVR comes with one user account, the Administrator account. The Administrator user name is admin and the password is
12345. The default password for Administrator should be changed right away for security reasons. The Administrator has the authority to
add, delete or configure parameters for many of the system functions.
Changing Password
You can change the default password by going to Menu > System Configuration > User, as shown in Figure 80.
Figure 80, User Settings Menu
To Next Page
Loading...
