HIKVISION DS-7600 Series

DS-7600 Series NVR User Manual
93
Enabling HDD Overwrite
Enabling HDD overwrite will allow the NVR to overwrite the installed disks once the disks are full.
To enable HDD overwrite:
1. Enter the HDD menu by going to Menu > System Configuration > HDD.
Figure 121, Record Information Menu
2. Select the Record Information tab, as shown in Figure 121.
3. Check the Overwrite checkbox.
4. Click the Apply button.
5. Click to exit.
Enabling HDD Sleeping
Enabling HDD sleeping will let the not recording HDD stay idle, in order to prolong its lifetime and save energy.
To enable HDD sleeping:
1. Enter the HDD menu by going to Menu > System Configuration > HDD.
Figure 122, Record Information Menu
2. Select the Record Information tab, as shown in Figure 122.
3. Check the Sleeping checkbox.
4. Click the Apply button.
5. Click to exit.
Configuring Quota Mode
Each camera can be configured with allocated quota for record. To configure quota mode:
1. Enter the quota mode menu by going to Menu > System Configuration > HDD.