HIKVISION DS-7604NI-E1 - Setting up Network Access

www.hikvision.com/en/us
Networking a NVR requires 3 steps:
1. Assign an IP address, Default Gateway, Subnet Mask, and a DNS server (Please
note: DNS, not DDNS) to the NVR
2. Forward the appropriate ports on the router (Port Forwarding).
3. Register DDNS (DDNS registration is required only if the public IP address is Dynamic).
To assigning an IP ADDRESS, go to “MENU”>”SYSTEM CONFIGURATION”>”NETWORK”
6. SETTING UP NETWORK
ACCESS
General
IP CONFIGURATION
Please note that the NVR’s default IP Address is set to 192.0.0.64
Enable
DHCP
With DHCP
enabled, the
router will
assign an IP
address to
the NVR
Select NIC
Type
Please Note:
After
enabling
DHCP,
The IP
configuration
becomes
“Greyed out”
REFRESH ↓