Quick Start Guide of Network Video Recorder
32
The live view interface may differ according to different models.
Interface Introduction
Displays the list of channels and the playing and recording status of each
channel.
Displays the image of channel, and multi-window division is supported.
Play control operations are supported.
Pan, tilt, zoom operations are supported, as well as preset editing and
calling.
PTZ function can only be realized if the connected camera supports PTZ control.
Starting Live View
Steps:
1. In the live view window, select a playing window by clicking the mouse.
2. Double click a camera from the device list to start the live view.
3. You can click the button on the toolbar to start the live view of all cameras on the device list.
Refer to the following table for the description of buttons on the live view window:
Select the window-division mode
Capture pictures in the live view mode
Enable/Disable digital zoom
Select different stream type for live
view by clicking the icon
: live view in main stream;
: live view in sub stream;
:live view in transcoded stream.
Recording
Before you start
Make sure the device is connected with HDD or network disk, and the HDD or network disk has been initialized
for the first time to use.
Two recording types can be configured: Manual and Scheduled. The following section introduces the
configuration of scheduled recording.
To Next Page
Loading...
Need help?
General
