HIKVISION DS-K1A802AMF-B User Manual

3.
Click Aendance Status.
4.
Set the aendance mode as Manual.
5.
Make sure Aendance Status Required is enabled.
Note
By default, Aendance Status Required is enabled.
6.
Set shortcut key from the drop-down list for the
aendance status.
7.
Click Save.
Result
Press a key on the device keypad to select an
aendance status and authencate. The
authencaon will be marked as the congured aendance status according to the dened
shortcut key.
Or when you
authencate on the device inial page, you will enter the Select Status page. Select a
status to take aendance.
Note
If you do not select a status for about 20 s, the authencaon will be failed and it will not be
marked as a valid aendance.
Set Auto Aendance
Set the aendance mode as auto, and you can set the aendance status and its available me
duraon. The system will auto change the aendance status according to the congured
parameters.
Before You Start
Add at least one person, and set the person's authencaon mode. For details, see Person
Management .
Steps
1.
Click Access Control → Advanced Funcon → More Parameters to enter the More Parameters
page.
2.
Select a device from the
le panel.
3.
Click
Aendance Status.
4.
Set the aendance mode as Auto.
5.
Make sure
Aendance Status Required is enabled.
Note
By default, Aendance Status Required is enabled.
6.
Set available me for the target aendance status.
1) Move the cursor on the target me and the enable checkbox will display.
2) Check the checkbox and set the available me.
DS-K1A802A Series Fingerprint Time Aendance Terminal User Manual
73

HIKVISION DS-K1A802AMF-B Specifications

General

Brand	HIKVISION
Model	DS-K1A802AMF-B
Category	Touch terminals
Language	English