HIKVISION DS-K1T802 Series - Page 17

Access Control Terminal·Quick Start Guide
9
3. Align the screw holes on the base with the screw sockets on the
wall.
4. Attach the mounting base on the wall with Inserting 4
KA4*22-SUS screws (supplied) into the 4 screw sockets.
Install the
Mounting Base
Attach the Front
Cover
5. Connect the corresponded cables.
6. Align the buckle of the front cover with the slot of the
mounting base, and hang the front cover onto the mounting
base. Make sure the buckle is embedded into the slot.
7. Secure the front cover with inserting and tightening two screws
on the bottom of device.
Secure the Front Cover