HIKVISION DS-K2M061 - 4.2 Install Secure Door Control Unit

Figure 4-2 DIP Switch（Binary 0011）
Note
• The DIP switch No. 1 to 3 are suitable for
seng the RS-485 communicaon address. No. 4 is for
Wiegand mode (OFF: Wiegand input, ON: Wiegand output).
• The DIP address cannot be repeated.
4.2 Install Secure Door Control Unit
Steps
1. Set the DIP of the secure door control unit according to the actual access control device
requirements.
Note
The DIP binary ranges from 0001 to 1111.
2. Drill holes on the wall or other places according to the mounng template.
Note
The minimum bearing weight of the wall or other places should be three mes heavier than the
device weight.
3. Insert the provided plasc sleeve of the A4 expansion screw into the punched hole.
4. Insert the cable into the cable socket, and insert the Wiegand cable into the Wiegand interface.
Cauon
If the cable needs to be connected from the side of the device, knock out the knockout hole on
one side.
5. Align the screw holes on both sides of the device with the sleeve in the wall and insert the
provided screws to
x the device.
DS-K2M061 Secure Door Control Unit User Manual
7