HIKVISION DS-K2M061 - Safety Instruction; Dangers; Cautions

Safety Instrucon
Dangers
• The socket-outlet shall be installed near the equipment and shall be easily accessible.
• An all-pole mains switch shall be incorporated in the electrical installaon of the building.
• Do not connect several devices to one power adapter as adapter overload may cause over-heat
or re hazard.
• If smoke, odors or noise rise from the device, turn
o the power at once and unplug the power
cable, and then please contact the service center.
• Shock hazard! Disconnect all power sources before maintenance.
• If the product does not work properly, please contact your dealer or the nearest service center.
Never
aempt to disassemble the device yourself. (We shall not assume any responsibility for
problems caused by unauthorized repair or maintenance.)
Cauons
• The equipment has been designed, when required, modied for connecon to an IT power
distribuon system.
• This equipment is suitable for mounng on concrete or other non-combusble surface only.
• The serial port of the equipment is used for debugging only.
•
• Install the equipment according to the
instrucons in this manual.
• To prevent injury, this equipment must be securely
aached to the oor/wall in accordance
with the installaon instrucons.
• No naked ame sources, such as lighted candles, should be placed on the equipment.
• Do not place the device in extremely hot (refer to the specicaon of the device for the detailed
operang temperature), cold, dusty or damp locaons, and do not expose it to high
electromagnec radiaon.
• The device cover for indoor use shall be kept from rain and moisture.
• Exposing the equipment to direct sun light, low
venlaon or heat source such as heater or
radiator is forbidden (ignorance can cause re danger).
• Please use a
so and dry cloth when clean inside and outside surfaces of the device cover, do
not use alkaline detergents.
• Please keep all wrappers
aer unpack them for future use. In case of any failure occurred, you
need to return the device to the factory with the original wrapper. Transportaon without the
original wrapper may result in damage on the device and lead to
addional costs.
DS-K2M061 Secure Door Control Unit User Manual
iii