DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 11
screen print from the left and the second “Dock A” screen print from the left.
If Device Supports Two Dock Stations: Use hanging bracket (1-2), and fasten six M6
stepped screws on the six hole sites on the vertical directions of the first “Host” screen
print from the left, the first “Dock A” screen print from the left, and the “Dock B” screen
print.
If Device Supports Three Dock Stations: Use hanging bracket (3-4), and fasten eight M6
stepped screws on the eight hole sites on the vertical directions of the second “Host”
screen print from the left, the second “Dock A” screen print from the left, the second
“Dock B” screen print from the left, and the second “Dock C” screen print from the left.
If Device Supports Four Dock Stations: Use hanging bracket (3-4), and fasten ten M6
stepped screws on the ten hole sites on the vertical directions of the first “Host” screen
print from the left, the first “Dock A” screen print from the left, the first “Dock B” screen
print from the left, the first “Dock C” screen print from the left, and “Dock D” screen print.
Figure 5, Hanging Bracket
2) Drill four holes on the wall according to the installation position and the rounded rectangle hole
sites on the hanging bracket.
3) Install the four expansion bolts, flat washers, spring washers, M8 nuts, and hanging bracket
according to the sequence shown as below. Then fasten the nuts with an M8 nut open-end
wrench.
To Next Page
Loading...