HIKVISION DS-MDS003 - Install Device (Desktop Mount)

DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 18
Before You Start
Prepare the desktop bracket components and accessories.
Steps
1. Insert the connecting pipes downward into the holes on the bracket base.
2. Fasten two M8 × 20 mm bolts into the holes on the triangle supports on the bottom of the connecting
pipes through two spring washers and two flat washers with an L-type hex wrench.
3. Fasten two M8 × 20 mm bolts into the holes on the base bottom through two spring washers and two
flat washers with an L-type hex wrench to fix the bottom of the connecting pipes to the base.
Result
Desktop bracket installation is completed.
Figure 18, Desktop Bracket Installation Effect
2.3.2 Install Device (Desktop Mount)
After installing the desktop bracket, follow the steps below to install dock station.
Before You Start
Prepare the hanging bracket and its accessories according to the device model.
Steps
1. Install the hanging bracket.
1) According to the device model, fasten M6 stepped screws on the hole sites with screen prints on
the upper and lower bulges of the hanging bracket with a cross screwdriver.
Refer to step 1 of “Wall Mount” for the detailed installation description.
2) Align the rounded rectangle hole sites on the hanging bracket to those on the bracket connecting
pipes, and guarantee the hanging bracket horizontal and stable.
3) Install the four M8 × 50 mm bolts, flat washers, spring washers, M8 nuts, and hanging bracket
according to the sequence shown as below. Then fasten the nuts with an M8 nut open-end
wrench.