HIKVISION DS-MDS003 - 2 Installation; Wall Mount

DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 10
Figure 4, Host Interfaces
Table 1-3 Host Interfaces Description
No.
Name
Description
1
Power Supply
100 to 240 VAC power supply
2
USB 2.0 Interface
To connect to a mouse or keyboard for software operation, or connect to a USB flash disk to upgrade the device
3
USB 3.0 Interface
Reserved
4
Network Interface
RJ-45 network interface for network access
5
RS-232 Serial Port
For debug
6
Power Switch
To turn on or off the power supply
7 On/Off Button
• When the device shuts down, hold it to start it up
•
When the device starts up, hold it to shut it down
2 Installation
Dock station supports wall mount, mobile mount, and desktop mount.
2.1 Wall Mount
You can install dock station on the wall.
Before You Start
• Prepare the hanging bracket and its accessories according to the device model.
• Prepare the tools such as electric drill, bit, etc. to drill holes on the wall.
Steps
1. Install the hanging bracket.
1) According to the device model, fasten M6 stepped screws on the hole sites with screen prints on
the upper and lower bulges of the hanging bracket with a cross screwdriver.
NOTE: If Device Supports One Dock Station: Use hanging bracket (1-2), and fasten four M6
stepped screws on the four hole sites on the vertical directions of the second “Host”