HIKVISION DS-MDS003 - Install Device (Mobile Mount)

DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 16
3. Install the horizontal shelf.
1) Adjust the shelf height according to the actual application scene, and align the holes on the shelf
to those on the connecting pipes.
2) Fasten four M8 × 70 mm bolts into the holes through four spring washers and four flat washers
from the front with an L-type hex wrench.
3) Fasten four M8 nuts onto the bolts from back with an M8 nut open-end wrench.
Result
Mobile bracket installation is completed.
Figure 15, Mobile Bracket Installation Effect
2.2.2 Install Device (Mobile Mount)
After installing the mobile bracket, follow the steps below to install dock station.
Before You Start
Prepare the hanging bracket and its accessories according to the device model.
Steps
1. Install the hanging bracket.
1) According to the device model, fasten M6 stepped screws on the hole sites with screen prints on
the upper and lower bulges of the hanging bracket with a cross screwdriver.
Refer to step 1 of “Wall Mount” for the detailed installation description.
2) Align the rounded rectangle hole sites on the hanging bracket to those on the bracket connecting
pipes, and guarantee the hanging bracket horizontal and stable.
3) Install the four M8 × 70 mm bolts, flat washers, spring washers, M8 nuts, and hanging bracket
according to the sequence shown as below. Then fasten the nuts with an M8 nut open-end
wrench.