HIKVISION DS-MDS003 - Dock Station Description; Interface Description

DS-MDS003 Dock Station (For DS-MCW405/32G/GPS/WIFI Body Cameras) Quick Start Guide
QSG DS-MDS003 0415221NA 9
1.3.3 Dock Station Description
Figure 3, Dock Station Overview
Table 1-2 Dock Station Description
No.
Name
Description
1 Body Camera Bin
There is a mini USB interface in each bin to connect a body camera. The bin door can be locked after you connect a
body camera in it, and it will automatically open if you pass the ID verification.
2 Indicator
The indicator shows the data collection and charging status of the connected body camera:
• Flashing blue: The dock station is collecting data of the body camera
• Flashing red: The body camera is being charged
• Solid green: The body camera is fully charged
3
Connection
Interface 1
To connect to another dock station
4
Connection
Interface 2
To connect to the host and communicate with it
5
Installation Hole
To hang the stepped screw on the hanging bracket when installing the dock station to the hanging bracket
6 Dial Switches
SW1 and SW2 are used to distinguish dock stations. You need to set the dial switches according to the table
printed above them.
NOTE: You must set the dial switches according to the table, or the device will fail to work.
1.3.4 Interface Description
The host interfaces on the host side are shown below.