40
Card/Tag Management
After adding cards/tags to the wireless AX PRO, you can swipe the card/tag to arm or disarm all
the detectors added to specific area(s) of the AX PRO, and silence alarms.
Note
The tag ID/PIN is a 32 bit long integer, and the variant could be 42949672956.
Steps
1. Enter the site, tap the AX PRO and then log in to the device (if required) to enter the page.
2. Tap → User Management to enter the page.
3. Tap a user to enter the configuration page.
3. Tap + to add a tag/keyfob.
4. When hearing the voice prompt "Swipe Tag", you should present the tag on the AX PRO tag
presenting area.
– When hearing a beep sound, the tag is recognized.
– The tag will be displayed on the tag list
5. Optional: Tap a tag to enter the configuration page.
6. Tap to edit the tag name.
Note
● If you log in as an installer, skip this step. Editing tag name is only available to administrator.
● The name should contain 1 to 32 characters.
7. Slide Enable Tag.
8. Select a linked user.
9. Select the tag type
Note
Different linked users have different tag permissions.
Operation Tag
You can swipe the tag to arm or disarm.
Patrol Tag
When you swipe the tag, the system will upload a record.
10. Optional: Tap Delete to delete the tag.
Device Information
You can change language and select time zone.
To Next Page
Loading...
Need help?
General
