EasyManua.ls Logo

HIKVISION DS-PS1-I-WE - User Manual

HIKVISION DS-PS1-I-WE
142 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
AX PRO
User Manual

Table of Contents

Other manuals for HIKVISION DS-PS1-I-WE

Questions and Answers

  • B
    Brenda WeaverSep 4, 2025
    Why am I unable to send mails to Yahoo from my HIKVISION DS-PS1-I-WE?
    • S
      suttonjeffreySep 4, 2025
      If you cannot send emails to Yahoo, the security level of your mailbox might be too high. Go to your mail account settings and enable 'less secure sign-in'.
  • L
    Lori SanchezSep 18, 2025
    What to do if the alarm clearing operation on the HIKVISION DS-PS1-I-WE Security System panel does not produce the alarm clearing report?
    • E
      Elizabeth RossSep 18, 2025
      If there is no alarm, no report will be uploaded for arm clearing.
  • J
    justin51Sep 16, 2025
    What to do if the HIKVISION Security System failed to send test mail?
    • T
      Tyler WilsonSep 16, 2025
      If the test mail fails to send, review and correct the mailbox configuration information as shown in table 1/1.
  • C
    Cameron MarquezSep 14, 2025
    What to do if HIKVISION DS-PS1-I-WE Security System zone triggered/fault?
    • C
      Christina SandersSep 14, 2025
      Reset the detector.
  • D
    Dr. Valerie James DDSSep 13, 2025
    What causes failure in arming HIKVISION DS-PS1-I-WE Security System?
    • X
      xthomasSep 13, 2025
      Arming may fail if the panel doesn't enable 'forced arming' and there's a fault in the zone. To fix this, either turn on 'forced arming' or restore the zone to its normal status.
  • R
    Rachel SmithSep 12, 2025
    What to do if HIKVISION DS-PS1-I-WE Security System zone is tamper-proof?
    • A
      Anthony CardenasSep 12, 2025
      Ensure the tamper-proof button of the detector is held down.
  • A
    Alicia CampbellSep 9, 2025
    What to do if my HIKVISION DS-PS1-I-WE Security System failed to send mail during use?
    • L
      Lawrence GonzalesSep 9, 2025
      If the system fails to send mail, it could be that the mailbox server has restricted access. Log in to your mailbox to check if it is locked.
  • D
    djohnsonSep 7, 2025
    Why am I unable to enter registration mode on my HIKVISION DS-PS1-I-WE?
    • J
      John RobertsSep 7, 2025
      If you can't enter registration mode, it might be because the panel is in 'Hotspot' mode. Switch the panel to 'station' mode and try again.
  • L
    lisareedSep 5, 2025
    What to do if HIKVISION Security System zone is offline?
    • A
      Andrew LeeSep 6, 2025
      If a zone is offline, it's likely because the detector reports undervoltage. Replace the detector battery to resolve this.
  • M
    Michael LoweAug 21, 2025
    How to fix HIKVISION DS-PS1-I-WE IP conflict?
    • V
      valerielambertAug 21, 2025
      To resolve an IP conflict, first, find the currently available IP address using the ping command. Then, change the IP address and log in again.

HIKVISION DS-PS1-I-WE Specifications

General IconGeneral
ModelDS-PS1-I-WE
CategorySecurity System
Detection Range12 m
Wireless Frequency868 MHz
Tamper ProtectionYes
Operation Humidity10% to 90% (non-condensing)
Humidity10% to 90% (non-condensing)
Operating Temperature-10°C to 55°C
Storage Temperature-20°C to 60°C
Wireless ProtocolWireless
Wireless Range100 m (open area)

Related product manuals