14
2. Select an area.
3. Set the following parameters according to actual needs.
Enable Auto Arm
Enable the function and set the arming start time. The zone will be armed according to the
configured time.
Note
● The auto arming time and the auto disarming time cannot be the same.
● The buzzer beeps slowly 2 minutes before the auto arming starts, and beeps rapidly 1
minute before the auto arming starts.
● You can select to enable forced arming on the System Options page. While the function is
enabled, the system will be armed regardless of the fault.
Enable Auto Disarm
Enable the function and set the disarming start time. The zone will be disarmed according to
the configured time.
Note
● The auto arming time and the auto disarming time cannot be the same.
Late to Disarm
Enable the function and set the time. If the alarm is triggered after the configured time, the
person will be considered as late.
To Next Page
Loading...
Need help?
General
