38
Alarm Center
You can set the alarm center’s parameters and all alarms will be sent to the configured alarm
center.
Steps
1. Click Communication → Alarm Receiving Center to enter the Alarm Receiving Center page.
2. Select the ARC1 or ARC3 for configuration, and slide the slider to enable the selected alarm
receiver center.
Note
Only if the alarm receiver center 1/3 is enabled, you can set the alarm receiver center 2/4 as the
backup channel and edit the channel parameters.
3. Select the Protocol Type as ADM-CID, ISUP, SIA-DCS, *SIA-DCS, *ADM-CID, or CSV-IP to set
uploading mode.
To Next Page
Loading...
