100
While enabled, the main power supply is off, Wi-Fi enters low power consumption, 4G closes,
tag reading fails, LED off, and voice prompt off.
Smoke Detector Reset
Click Reset to reset the smoke detector
Schedule and Timer Settings
You can set the alarm schedule. The zone will be armed/disarmed according to the configured
time schedule.
Steps
1. Click System → System Options → Schedule & Timer to enter the Schedule & Timer page.
2. Select an area.
3. Set the following parameters according to actual needs.
Enable Auto Arm
Enable the function and set the arming start time. The zone will be armed according to the
configured time.
Note
● The auto arming time and the auto disarming time cannot be the same.
● The buzzer beeps slowly 2 minutes before the auto arming starts, and beeps rapidly 1
minute before the auto arming starts.
● You can select to enable forced arming on the System Options page. While the function is
enabled, the system will be armed regardless of the fault.
To Next Page
Loading...
Need help?
General
