3.3 Event Playback
When you select the event playback mode, the system will analyze and mark videos that contain
the motion detection, line crossing detection, or intrusion detection information, .
Before You Start
● Ensure the camera has enabled Dual-VCA. You can enable it via the camera web browser
interface in Configuration → Video/Audio → Display Info. on Stream.
● Ensure your video recorder has enabled Save VCA Data. You can enable it in Configuration →
Record → Advanced.
Steps
1. Go to Playback.
2. Click Event.
3. Select a camera.
Figure 3-4 Event Playback
4. Position the cursor on playback window to show control bar.
Table 3-3 Button Description
To Next Page
Loading...
