HIKVISION iDS-TCM403-AI - Set FTP

4.1.2 Set FTP
Set FTP parameters if you want to upload the captured pictures to the FTP server.
Before You Start
Set the FTP server, and ensure the device can communicate normally with the server.
Steps
1.
Go to
Conguraon → Network → Data Connecon → FTP .
Figure 4-2 Set FTP
2.
Check Enable FTP.
3.
Select Number of Enabled FTP.
Note
You can only enable one FTP if the device does not support the violaon capture, or you should
set dierent uploaded data for each FTP respecvely.
Example
If you select FTP 1 as Upload Checkpoint Data, FTP 2 will be selected as Upload
Violaon Data
by default.
4.
Set FTP Parameters.
1) Select Sever Address Type and enter corresponding
informaon.
2) Enter Port.
3) Enter User Name, Password, and conrm the password.
4) Select Protocol Type.
5) Select Directory Structure.
Note
You can customize the directory structure according to your needs.
5.
Oponal: Enable upload funcons.
Network Trac Camera Operaon Manual
14