HIKVISION iDS-TCV907-BER - 6.5 Set QoS; 6.6 Set IEEE 802.1 X

6.5 Set QoS
QoS (Quality of Service) can help improve the network delay and network congeson by seng
the priority of data sending.
Note
QoS needs support from network devices such as routers and switches.
Steps
1.
Go to Conguraon → Network → Network Parameters → QoS .
Figure 6-7 Set QoS
2.
Enable Video/Audio DSCP, Event/Alarm DSCP, and Management DSCP according to the actual
needs.
Note
Network can idenfy the priority of data transmission. The bigger the DSCP value is, the higher
the priority is. Same sengs need to be set in the router for conguraon.
3.
Click Save.
6.6 Set IEEE 802.1X
IEEE 802.1X is a port-based network access control. It enhances the security level of the LAN/
WLAN. When devices connect to the network with IEEE 802.1X standard, the
authencaon is
needed.
Steps
1.
Go to Conguraon → Network → Network Parameters → 802.1X .
Network Trac Camera Operaon Manual
39