UM DS-2CCx2D9T-xxxx 022520NA (UD02874B-A) 30
Figure 17, Affix Inclined Base
3. Route the cables through the inclined base hole.
4. Attach the type I camera back box/type II camera base plate to
the inclined base with the supplied screws.
Figure 18, Affix Camera to Base
5. Repeat steps 6 to 9 of the
2.1.1 Ceiling Mounting
section to
complete the installation.
2.3. Type III and Type IV Camera Installation
2.3.1. Ceiling Mounting
Both wall mounting and ceiling mounting are suitable for
the bullet camera. Ceiling mounting will be used as an
To Next Page
Loading...
