HIKVISION TurboHD DS-2CC 2D9T Series - Page 33

UM DS-2CCx2D9T-xxxx 022520NA (UD02874B-A) 33
Figure 21, Internal Interface and Button
8. Power on the camera to check if the image on the monitor is at
an optimum angle. If not, adjust the surveillance angle.
1) Loosen the no.1 adjusting screw to adjust the pan position
[0° to 360°].
2) Tighten the no. 1 adjusting screw.
3) Loosen the no. 2 adjusting screw to adjust the tilting
position [0° to 90°].
4) Tighten the no. 2 adjusting screw.
5) Loosen the no. 3 adjusting screw to adjust the rotation
position [0° to 360°].
6) Tighten the no. 3 adjusting screw.