14
GAS CYLINDER USE
GAS CONNECTIONS
In the case of a problem arising with the hose and regulator please contact your gas
oven supplier for a list of approved replacement parts . The hose and regulator
assembly parts must be an indicaon gas associaon approved part.
LEAK TESTING
This should be done the first me you connect up the pizza oven, and again every
me you disconnect and reconnect any fing. Inspect the hose before each use.
Turn the gas on at the cylinder, or make sure gas is available to the barbecue, but do
not turn the burners on. This fills the gas lines with gas. Now brush or pour some
soapy water onto all connecons. If there is a leak, bubbles should appear within
about 20 seconds. If you find any leaks, ghten the connecon. If the leak
persists, contact your place of purchase.
As an alternave, you may use a gas leak detector, following the manufacturer’s
instrucons, available at all major barbecue retailers. This provides an easier way to
check for leaks.
To Next Page
Loading...