Hiland SPOA - Operating Instructions; Lighting Procedure; Manual Ignition; Pulse Igniter Ignition

15
DO NOT USE NAKED FLAME FOR LOCATING GAS LEAKS.
IF A LEAK PERSISTS, CALL AN AUTHORISED PERSON.
WARNING
STORE CYLINDER IN A WELL VENTILATED AREA
OUT OF REACH OF CHILDREN
OPERATING INSTRUCTIONS
LIGHTING PROCEDURE
1. Lighng the gas oven is easy, but must be done with care.
2. Make sure that gas is turned on at the cylinder, or that gas is available to the gas
oven.
3. Make sure the LPG cylinder is filled.
4. Check that the end of the burner tube is properly located over the valve orifice.
5. Make sure all gas connecons are securely ghtened.
6. Open the gas oven door.
7. Line the grease tray with crumpled aluminium foil.
MANUAL IGNITION
Place a lighted match or gas lighter (not provided). Keep your hand below the boom
of the burner while doing this. Now turn the burner on. You should
See the burner light. Repeat to light the other burners.
PULSE IGNITER IGNITION
Note: Pulse igniter requires one AA baery to operate.
1. Ensure the door is open before lighng the burner.
2. Make sure the knob is in the “OFF” posion.
3. Press and turn THE KNOB to the “HIGH” posion and hold down the KNOB. While
holding down the KNOB, press the “PULSE IGNITON” buon to light the burner.
4. Connue pressing the “PULSE IGNITOR” buon for the next 3 to 5 seconds. Once
the burner is lit, connue holding down the KNOB for another 5 to 8 seconds before
releasing the knob.
5. If the burner FAILS TO light, turn the KNOB to the “OFF”posion and wait for
another 5 minutes before repeang the above steps.