Hills 4 - Safety Instructions

3
Safety
Instructions
Safety Instructions
Caution: contents under pressure.
Read this before operating.
• Releasepressurefromthebottlebefore
relling or replacing parts. This is done by
slowly pulling up the safety valve and holding
until all air has been released. Then unscrew
the container cap. Note: some remaining air
may be expelled.
• Inspecttheconditionofallttingsbefore
each use. Do not attempt to use your
sprayer with worn or damaged parts.
These parts should be replaced. Refer to
spare parts list.
• Safetyvalveoperation:overpumpingwill
cause the safety valve to open and release
excess pressure. It will close when safe
operating pressure is reached.
• Safetyvalvetest:llthebottletothe
maximum lling level with clean water.
Pressurise by pumping a few times. Once it
has reached full pressure the valve should
lift, allowing the red indicator to become
visible and air to escape. If this does not
happen, replace the safety valve.
• Yoursprayerismadefrommanydifferent
types of plastic materials, and although
the liquid you may wish to use is packed in
a plastic container, it is not guaranteed
thatitwillnotdamageyoursprayer.Your
sprayer is designed for use with a broad
range of domestic water based herbicides,
fungicides, insecticides and fertilisers.
Do not use other types of chemicals as they
may be detrimental to the safe operation
of your sprayer.
• Followchemicalsupplierson-packinstructions.
HLS0070_GardenSprayer_Produc_Manual_v5.indd 3 20/06/13 12:47 PM