Hills 4 - Operation; Operating Instructions

6
Operation
Operating Instructions
Important: Rinse the inside of the bottle with
cold water before use. Before using with any
chemicals it is advisable to familiarise yourself
with the sprayer by trialing it rst with water
only. Thick mixtures can clog the spray
nozzle. Mixtures of this kind should be
strained to prevent blockages. Wash the
bottle, attachments and your hands
thoroughly after use.
Before Use
• Removetheinternalpumpassemblyby
unscrewingthecontainercap.Fillliquid
to the required level. Do not exceed the
“MAXIMUM FILLING” level.
• Insertinternalpumpassemblyandtighten
container cap rmly by hand.
• Makesurethesafetyvalveandhoseretainer
cap are tight to prevent air escaping.
• Firmlyscrewthelanceassemblytothe
trigger handle.
Operation
• Pumpthesprayeruntilthesafetyvalvestarts
toopenandvent.Yoursprayerisdesigned
tooperateat40P.S.I.(275kpa).Youwill
notice that when the sprayer is at full
pressure the safety valve will lift and a red
indicator becomes visible.
• Pumpperiodicallytomaintainconstant
spraying pressure.
• Lockpumphandleintocontainercap.This
allowsyoutocarrythesprayer.Youcanalso
use the strap supplied.
• Startsprayingbypressingtheon/offtrigger.
The trigger is equipped with a lock for
continuous spraying. To lock, press the
trigger and slide the trigger lock forward.
To unlock, slide the trigger lock back and
release the on/off trigger.
• Choosethetypeofnozzleaccordingtoyour
spraying application. Turn the nozzle
to obtain the desired spray pattern.
HLS0070_GardenSprayer_Produc_Manual_v5.indd 6 20/06/13 12:47 PM