Hillstone SG-6000-E6360 - Table 1-31: QSFP+ Optical Module Attributes; Table 1-32: XFP Port Attributes

25
Chapter 1 Introduction | Hillstone
Hillstone SG-6000 E-Series Hardware Reference Guide
Caution: To avoid dust falling into the QSFP+ socket, you should place a rubber dust
cap (originally in the accessory box) over the QSFP+ port.
Table 1-31: QSFP+ Optical Module Attributes
Attribute
Description
Short-haul Multimode
Optical Module (850nm)
Ultra-long Haul Single-
mode Optical Module
(1550nm)
Connector
MPO
LC
Fiber Type
50/125μm multi-mode fiber
9/125μm single-mode
fiber
Maximum
Transmission
Distance
0.3km
10km
Central Wavelength
850nm
1310nm
Optional Factory
Module
TRAN-SR-QSFP+
TRAN-LR-QSFP+
Caution: When using the optical module of Hillstone Network factory, it is
recommended not to mix with other manufacturers' optical modules, otherwise some
abnormal problems may arise
XFP Port
Hillstone devices support XFP ports which use XFP optical modules.
Table 1-32: XFP Port Attributes
Attribute
Description
Connector
XFP
Frame Format
Ethernet_II
Ethernet_SNAP
Negotiation Mode
XFP optical module
10Gbps
Hillstone device supports four types of 10GBase-FX XFP optical module. All optical
modules are hot-swappable.
Caution: To avoid dust falling into the XFP socket, you should place a rubber dust cap
(originally in the accessory box) over the XFP port.