Hillyard TRIDENT R30SC User Manual (English)

Other manuals for Hillyard TRIDENT R30SC

Questions and Answers:

larrybellAug 1, 2025

Why won't my Hillyard Scrubber start?

R
ricky29Aug 1, 2025
If your Hillyard Scrubber won't start, there are several potential causes. First, ensure the main switch is in the "I" position by turning the key a quarter turn clockwise. Also, verify that there are no alarm messages on the control display when you switch it on. Make sure the batteries are correctly connected to each other and that the battery connector is properly connected to the electrical system connector, referring to the section titled “INSERTING THE BATTERIES INTO THE MACHINE” for guidance. Finally, check the battery charge level and perform a complete recharge cycle if it's critically low, referring to the paragraph “CHARGING THE BATTERIES”.

Travis MillerAug 16, 2025

What to do if Hillyard Scrubber batteries are not charging correctly?

O
operkinsAug 16, 2025
If your Hillyard Scrubber batteries aren't charging correctly (for versions without an on-board battery charger), start by ensuring the battery charger cable connector is properly inserted into the battery connector. Then, check that the plug on the battery charger's power cable is correctly inserted into the electrical outlet. Also, verify that the characteristics of the mains power supply match those required by the battery charger, as indicated on the battery charger plate. Finally, if the LEDs on the battery charger are blinking repeatedly, you should consult the battery charger's use and maintenance manual to understand the meaning of these signals during the battery recharge stage.

Model

TRIDENT R30SC