HiLook IPC-T220H-U - Page 22

Network Turret Camera·Quick Start Guide
21
Steps:
1. Paste the drill template to the wall.
2. Drill screw holes and the cable hole (optional) on the wall
according to the supplied drill template.
Note:
Drill the cable hole, when adopting ceiling outlet to route the cable
Screw
Hole
Cable
Hole
Figure 2-10 Drill Template
3. Disassemble the inclined base by the screw driver.
4. Install the turret camera's mounting base on the inclined base
cover with three PM4 screws.
Inclined Base
Cover
Mounting
Base
Figure 2-11 Fix Camera's Mounting Base