Hilti DWP 10 - Use; Operating the water supply unit; After use; Cleaning and storage

English 5
6 Use
1. Connect the plug-in connector of the water pressure tank with the plug-in nipple [1].
2. Actuate the ball valve.
◁ The liquid supply begins.
◁ The liquid quantity can be regulated with the ball valve.
3. Continue pumping if the pressure drops below 1 bar [2].
4. When the tank is empty, refill it.
7 After use
1. Pull up the red button of the safety valve until the tank is completely depressurized.
2. Close the ball valve and disconnect the plug-in connection and plug-in nipple [1].
3. Lock the pump handle.
4. Screw the pump out of the tank.
5. Drain the remaining water from the tank.
6. Wipe off the water supply unit with a damp cloth.
7. Coil the hose around the tank and mount the plug-in connection on the locating pin of the water supply
unit [2].
8. Keep the water supply unit in a dry, frost-free environment protected from direct sunlight for drying and
storage.
Printed: 30.05.2018 | Doc-Nr: PUB / 5433246 / 000 / 00