What to do if Hilti Dispenser power tool does not work and one LED flashes?
If your Hilti Dispenser power tool doesn't work and one LED flashes, it could be due to a low battery. Try changing the battery and charging the empty one. Alternatively, the battery might be too hot or too cold, in which case you should also try changing the battery.
Why does my Hilti HDE 500-A22 Dispenser power tool or battery get very hot?
If your Hilti Dispenser power tool or battery gets very hot, it could be due to overloading the tool by exceeding application limits. Check the power and performance rating of the product to ensure it's suitable for the job. Refer to the “Technical data” section.
How to fix Hilti HDE 500-A22 Dispenser power tool that does not work?
If your Hilti Dispenser power tool doesn't work, there are a few potential causes. First, make sure the battery is fully inserted by pushing it in until it engages with an audible double click. Second, check if the battery is low and replace it with a charged one. Lastly, ensure that the dispensing mode selector switch is not set to “0”; select the desired dispensing volume instead.
Why is no mortar dispensed from the mixing nozzle of my Hilti Dispenser?
If no mortar is dispensed from the mixing nozzle of your Hilti Dispenser, the mortar in the mixing nozzle may have hardened. To resolve this, unscrew the mixing nozzle containing the hardened mortar and fit a new mixing nozzle.
Read this documentation before initial operation or use for safe handling and use.
Explains signal words like DANGER, WARNING, CAUTION, and symbols used in the document and illustrations.
Details product type, generation, and serial number for service inquiries.
States compliance with directives and standards, and location of technical documentation.
Provides essential safety instructions for work area, electrical, and personal safety.
Emphasizes compliance with all safety instructions and usage guidelines before operating the tool.
Step-by-step guide on how to insert the battery into the dispenser.
Step-by-step guide on how to remove the battery from the dispenser.
Instructions for correctly inserting the foil pack holder and foil pack into the dispenser.
Provides a detailed labeled diagram of the HDE 500-A22 dispenser and its components.
Specifies the intended application and compatible consumables for the HDE 500-A22 dispenser.
Lists the items included with the dispenser and where to find information on other approved products.
Details the weight and rated voltage specifications for the HDE 500-A22.
Provides a table to diagnose common issues and their possible causes and actions.
Instructions and precautions for safely transporting the tool and batteries.
Guidelines for safe and proper storage of the tool and batteries to prevent damage.
Specific instructions for transporting and storing the dispenser unit.
Information on recycling Hilti tools and safe disposal of batteries, avoiding household waste.
To Next Page
General
