26
9. Care and maintenance
9. Care and maintenance
9.1 Cleaning and drying
–Blow dust off the lenses.
–Do not touch the glass with your fingers.
–Use only a clean, soft cloth for cleaning. If necessary,
moisten the cloth slightly with pure alcohol or a little
water.
-NOTE-
– Do not use any other liquids as these may damage the
plastic components.
– Observe the temperature limits when storing your
equipment. This is particularly important in summer if
the equipment is kept inside a motor vehicle (storage
temperature -20°C to +63°C / -4° to 145°F).
9.2 Storage
Remove the tool from its case if it has become wet. The
tool, its carrying case and accessories should be
cleaned and dried (max. temperature: 40°C / 104°F).
Repack the equipment only when it is completely dry.
Check the accuracy of the equipment before it is used
after a long period of storage or transportation. Remove
the batteries if the tool is not used over a long period.
Leaking batteries may damage the tool.
To Next Page
Loading...
Need help?
General
