Hilti PR 30-HVS User Manual

PR 30-HVS I Quick Guide I 2014
1
www.hilti.com.au
Shock-Mode
Deactivation:
PR 30-HVS Quick Guide – Functions
PRA 30 Settings
Slow
beeping
Solid beep
Fast
beeping
Press ON/OFF
Wait for Laser
1. Press ON/OFF
3. Press Shock-Mode button to
deactivate Shock-Mode
4. LED indicates Shock-Mode is
deactivated
2. Shock-Mode activates
automatically after 2 minutes
Basic Application
3. If rotator is bumped, laser
stops rotating and all LEDs
activate
Press Volume Key to
change Volume
(normal/loud/off/low)
Press Unit Key to
change units (mm/cm)
Pairing:
All tools sent out paired - Pairing
only for new receiver!
1. Press and hold ON/OFF on both
PR 30-HVS and PRA 30 for three
seconds
2. LEDs blink, PRA beeps, Icon appears

Hilti PR 30-HVS Specifications

General

Self-leveling range	±5°
Laser class	Class 2
Laser wavelength	635 nm
Operating temperature range	-20 - 50 °C
Rotation speed	600 rpm
Operating time with Alkaline batteries	40 h
Protection class	IP 66
Self-leveling time	30 seconds

Summary

PR 30-HVS Quick Guide – Functions

Basic Application

Overview of basic laser tool application and startup process.

Shock-Mode

Instructions for activating, deactivating, and the behavior of the Shock-Mode feature.

PRA 30 Settings

Guide to adjusting volume and units for the PRA 30 receiver.

Pairing

Steps for pairing the PR 30-HVS laser with the PRA 30 receiver.

PR 30-HVS Quick Guide – Vertical Alignment

Vertical Auto Alignment

Procedure for automatically aligning the laser vertically.

Vertical Manual Alignment

Procedure for manually aligning the laser vertically.

PR 30-HVS Quick Guide – Slopes

Setting Slopes

How to set the desired slope inclination using the target and tool.

Slope e-Targeting

Using the e-Targeting feature for accurate slope setting and alignment.

Determining Slopes

Process for determining slopes with the laser tool and receiver.