48
Automatic cut-out
In the case of automatic levelling of one or both
directions, the servo system monitors adherence to
the specified accuracy. Cut-out takes place:
- if levelling is not achieved (levelling range
exceeded or mechanical blockage)
- if the tool is put out of plumb (shock/jolt).
After switch-off has taken place, the rotation switches
off, the laser beam flashes, the Operation LED
flashes red, alternating with the Incline LED.
Increased visibility of the laser beam
Laser beam visibility varies depending on the
working distance and ambient brightness. With the
aid of a special reflective plate (beam catcher), the
beam can be “caught” and held at a specific point.
The laser beam oscillates automatically at the
desired point within a range of approx. ± 200 to 500
mm. This arc therefore appears considerably
brighter.
The beam catcher is used at distances
of 1 – 30 m.
For distances of 1 – 100 m, the manual
detector (optional) is used.
Continued
1. Product information
Functional description, continued
To Next Page
Loading...
Need help?
General
