Hilti PS 85 - Additional safety instructions; Personal safety; Electrical safety; Using and handling the measuring tool

12 English 2327817
*2327817*
▶ Due to the measuring principle employed, the results of measure-
ments can be negatively affected by certain ambient conditions.
These include, for example, the proximity of devices that produce
strong magnetic or electro-magnetic fields, vibrations and temperature
changes.
▶ Rapidly changing measuring conditions can falsify the results.
▶ When the product is brought into a warm environment from very cold
conditions, or vice-versa, allow it to become acclimatized before
use. Big differences in temperature can lead to incorrect operation and
incorrect results.
▶ When adapters or accessories are used, make sure they are
mounted securely.
▶ The measuring tool is designed for the tough conditions of jobsite
use, but as with other optical and electrical products (e.g. binoculars,
spectacles, cameras) it must be handled with care.
▶ The specified operating and storage temperatures must be ob-
served.
2.2 Additional safety instructions
Personal safety
▶ Keep the measuring tool well away from all implants.
▶
Comply with the national accident prevention regulations.
▶ Do not use the measuring tool to examine humans or animals.
▶ Operation of the device in the proximity of expectant mothers or persons
with a cardiac pacemaker is not permissible.
Electrical safety
▶ Remove the battery prior to storage.
Using and handling the measuring tool
▶ Prior to use, always check the measuring tool's presettings and the
settings you have made yourself.
▶ After switching on and while using the product, always pay attention to
the information and warnings that appear on the display.
▶ Keep the underside of the scanner and the wheels clean as these parts
can have an influence on measuring accuracy.
▶ Do not affix stickers or adhesive labels to the sensor area at the back
of the measuring tool. Metal plates / labels, in particular, will affect
measuring results.
▶ While measuring is in progress, always keep all 4 wheels in contact with
the surface being scanned. Do not pass over steps or edges.
▶ While scanning is in progress, to avoid influencing the scan hold the
measuring tool only by the grip provided for the purpose.