Hilti RT 6-A22 User Manual

10 English 2225142
*2225142*
▶ Store the product and the batteries in a cool and dry place. Comply with the temperature limits stated in
the technical data.
▶ Do not store batteries on the charger. Always remove the battery from the charger when the charging
operation has completed.
▶ Never leave batteries in direct sunlight, on sources of heat, or behind glass.
▶ Store the product and batteries where they cannot be accessed by children or unauthorized persons.
▶ Prior to each use and before and after prolonged storage, check the product and the batteries for
damage.
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
9.1 Blind-rivet setting tool is not in working order
Malfunction Possible cause Action to be taken
The LEDs do not light up. The battery is not fully inserted. ▶ Push the battery in until it
engages with a click.
Battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Bring the battery to the recom-
mended working temperature.
1 LED flashes. Battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Bring the battery to the recom-
mended working temperature.
4 LEDs flash. Product momentarily overloaded. ▶ Release the control switch and
then press it again.
Protection against overheating. ▶ Allow the product to cool down
and clean the air vents.
Overload protection. ▶ Remove metallic residues . 8
Blind rivet is not set. Battery is discharged. ▶ Change the battery and charge
the empty battery.
Jaws are dirty or worn. ▶ Clean the jaws or, if applicable,
8 replace them.
Jaw housing not correctly screwed
on.
▶ Screw the jaw housing on
correctly . 8
Spring weak or defective. ▶ Replace the spring . 8
No rivet mandrel disposal. Use of the wrong nosepiece. ▶ Change the nosepiece . 7
Nosepiece is worn. ▶ Change the nosepiece . 7
Rivet mandrel wedged in jaws. ▶ Remove the rivet-mandrel
residues from the jaw housing .
8
Steel sleeve is dirty. ▶ Clean the steel sleeve . 8
Mandrel container is full. ▶ Empty the mandrel container .
8
10 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
▶ Do not dispose of power tools, electronic equipment or batteries as household waste!

Hilti RT 6-A22 Specifications

General

Type	Hand gun
Product color	Black, Red
Rivet sizes supported	2.4, 3.2, 4, 4.8, 5 mm
Mandrel diameter range	2.4 - 5 mm
Country of origin	Germany
Power source	Battery
Battery voltage	22 V
Quantity per shipping (inner) case	1 pc(s)
Battery included	No

Weight and Dimensions

Height	286 mm
Weight	1650 g
Package depth	433 mm
Package width	2076 mm
Package height	400 mm
Package weight	3055 g