Hilti RT 6-A22 User Manual

*2225142*
2225142 English 7
5 Preparations at the workplace
5.1 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. 5
5.1.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.1.3 Removing the battery
1. Press the battery release buttons.
2. Remove the battery from the tool.
5.1.4 Changing the nosepiece
CAUTION
Risk of injury A blind rivet can injure you.
▶ Make sure there is no blind rivet in the fastening tool.
1. Press and hold down the switch.
2. Use a ring wrench of the correct size (12 mm) to slacken the nosepiece and unscrew it.
3. Screw the new nosepiece into position.
4. Use a ring wrench of the correct size to tighten the nosepiece.
6 Types of work
6.1 Setting a blind rivet
1. Install the correct nosepiece for the rivet diameter you are going to use.
2. Insert the blind rivet into the nosepiece.
3. Hold the product in position on the workpiece.
Only predrilled workpieces can be riveted.
4. Briefly press the switch to set the blind rivet.
5. Tilt the product to the rear so that the sheared rivet mandrel can drop into the mandrel container.

Hilti RT 6-A22 Specifications

General

Type	Hand gun
Product color	Black, Red
Rivet sizes supported	2.4, 3.2, 4, 4.8, 5 mm
Mandrel diameter range	2.4 - 5 mm
Country of origin	Germany
Power source	Battery
Battery voltage	22 V
Quantity per shipping (inner) case	1 pc(s)
Battery included	No

Weight and Dimensions

Height	286 mm
Weight	1650 g
Package depth	433 mm
Package width	2076 mm
Package height	400 mm
Package weight	3055 g