Hilti ST 1800 - Technical Data; Operation

*378504*
378504 English 13
Application Screw type Diameter
in mm
Torque
setting
Sandwich panel to wood SCDW 61 6.5 5 - 8
3.4 Items supplied
Metal construction screwdriver, STDG 17 depth guage, operating instructions.
4 Technical data
4.1 Technical data
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the tool is powered by a generator or transformer, the generator or transformer’s power output must be
at least twice the rated input power shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
ST 1800
Weight
1.9 kg
Speed (running under no load)
0 /min … 1,900 /min
Max. torque
22 Nm
Chuck
1
/
4
" hex socket
Protection class
II
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintenance of the electric tool and accessory tools, keeping the hands warm,
organization of work patterns.
Noise information
Sound power level (L
pA
)
84 dB
Sound pressure level (L
wA
)
95 dB
Uncertainty
3 dB
Vibration information
Triaxial vibration value
2.5 m/s²
Uncertainty (K)
1.5 m/s²
5 Operation
Switching on
Press the control switch slowly all the way.
Activating continuous running mode
Switching off steady-state operation
Removing the protective sleeve
2
Setting the torque
6
Printed: 24.07.2018 | Doc-Nr: PUB / 5070705 / 000 / 05