CANCELLED Number 3
Not Programmed
Followed by
7
Number 03
122668899
Do you want to delete?
7=YES
9=NO
3.1.3 Deleting telephone numbers
In order to delete a telephone number, enter the menu “Telephone book” and press the buttons
until you put in evidence:
Press and choose with the telephone number you want to delete.
On the display will appear:
Confirm the choice with the button or .
The diplay will show:
press the button in order to confirm the cancellation.
On the diplay will appear for a few moments:
At the end, press or in order to come back to the former menu.
3.2 Setup
Enter the program menu and dial or use the buttons in order to visualize:
And press or .
Writes key - Write the memorized code in the central computer on a key.
Reads key - Read the code from a key and memorize it in the central computer.
New Key Code - Memorize the new code in the central computer.
SETUP Code - Modify the SETUP code to access to the program.
USER Code - Modify the USER code for the access to the commands.
Entrance timing - Modify the timer entrance.
Exit timing - Modify the timer exit.
Alarm duration - Modify the duration of the alarm of the sirens.
Maxium 5 cycles all. - Limit the maximum numbers of the cycles of alarm for every insertion.
Zone Log/Bal - Configure the zone lines with a logical or balance entrance.
IR on Area 1 - To enable or less the detector infrared placed on the panel to alarm the 1 zone
Partial instal A - Which zones check with a partial insertion A.
Partial instal B - Which zones check with a partial insertion B.
Ins. Input key - To allow to configure which type of connection will made with a pulse on the
Ins. from Keyfob - To select which type of connection will be made from two button remote controls
(DXR20/XR20)
Beep key reader - Adjust the loudness of the beep of the key readers DX300.
Privacy key readers. - Hide the information about the status of the central computer and of the key readers
DX300.
Beep All key readers. - play audible alarm on the key readers DX300.
Radio Code - Code of 18 binary digits (a sequence of “0” and of “1” )
Devices 485 - Enable the key readers on the bus RS485..
24h Device 485 - Enable alarm 24 h when lacking the link of the devices on bus RS485.
Functions OUT + INT - Mode of operation of the output + INT.
Forwarding SMS - Sending the received SMS to the first number in the telephone book.
Module GSM - Enable module GSM.
In order to exit the SETUP menu and come back to the program menu, press or .
terminal
block “KEY”.
2
8
765
2-Setup
2
Inst.Disconnected
Delete numbers
TELEPHONE BOOK
Programming
security
PROTEC4GSM - PROTEC8GSM - Installation guide and use
security
1918
To Next Page
Loading...
