EasyManua.ls Logo

Hiltron security PROTEC5X - 1.3 Technical features

Hiltron security PROTEC5X
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 Installation
2.1 General instructions
! Do not install the device at places exposed to the bad weather or to the extreme
temperatures.
! The central unit is protected from the opening, but the installation in a safe place is a
greater protection of the device.
! For a strong and safe fixing, it needs making sure the wall surface is plane.
! Fixing the device by the four fishers included in the central unit and no replacing them with
others of more small size.
! Fixing the central unit at a height that allows an easy access to the frontal panel.
! The central unit must be connected with an alarm system according to CEI 79-3 Standard
or similar.
2.2 Power supply
It ‘s important to know that the entire system is powered exclusively by the 12V 7,5Ah lead
battery inside of the burglary central unit; the lead battery is constantly in charge by the power
supplier/battery connected to the 230V~ main power supply.
28
1.3 Technical features
! Operating voltage: 230V~ ±10% 50Hz
! Maximun current absorption: 140mA
! Service output voltage: 13V! ±5%
! Maximum current supplied in services output: 650mA
! Fuse on services output voltage: F type 1A
! Maximum current supplied in sirens output: 3A (connected to the battery)
! Fuse on sirens output: F type 3,15A
! Maximum current supplied by power supplier : 1A
! Minimum operating temperature: 5±2°C
! Maximum operating temperature: 40±2°C (relative humidity 93±2%)
! Container protection level: IP30
! Buffer battery: 12V 7Ah
! Transformer primary fuse: F type 250mA
! Transformer secondary fuse: F type 2A
! Central unit dimensions: 280x230x95mm
! Electronic key dimensions: 50x20x10mm
! Insulation class:
! Prestation level: 1st
!
29
InstallationPROTEC5X - User’s manual
230V~
50Hz
main power supply
Switch
WARNING!
The main power supply 230V~ has to be connected to the power supplier/battery
charger by two 1,5mm² double-isolation wires coming from a sectioning switch(i.e. a
magneto-thermic protection switch) used exclusively for the burglary central unit.
Inside of the central unit positioning orderly the two wires, locking them by wrappers.
security security

Table of Contents

Related product manuals