NOAHlink Users Manual
16
6 Battery Usage
When installing your NOAHlink, you can use either rechargeable or
alkaline batteries. This section describes the procedure to use for
each battery type.
NOTE: It is recommended that you keep alkaline batteries
available when using your NOAHlink in case you forget
to recharge your rechargeable battery and it runs down
during a patient session.
NOAHlink is powered by battery – rechargeable or alkaline. The
battery is placed in the compartment at the bottom of the unit, as
illustrated below:
Figure 3: NOAHlink and Battery Lid
6.1 Alkaline Battery
Simply open the battery compartment of your NOAHlink unit and
place one alkaline AA (R6) 1.5V battery inside in the correct
position by matching the symbols on the battery to those on
NOAHlink.
To Next Page
Loading...
